Decal installation instructions decalnetwork

Decalnetwork Installation instructions: tions: Vinyl decals will stick to about any clean smooth surface. Make sure it is free of dirt, wax and grease. We recommend installation temp. of surface between 40 - 90 degrees. Tools to have on hand for install - tape measure, pencil, paper tows, scissors, masking tape, windex or alcohol, squeege or credit card. Note: Our products are 100% guaranteed against manufacturing defects. Even though this process is not difficult for most people, it can be a little difficult for some . Larger decals require more experience (they should be applied wet). We guarantee decals when we install them but we can guarantee it, if not install properly or you destroy it during installation. Do Not Abuse: Do not directly power wash decals or scrape with ice scraper. Windshield wipers will not hurt these decals. For any questions about installation Please contact us.
	The flash movie above, is a better example of installing smaller sized decals. As our fundraising and novelty decals.
	Take the decal as you received it. Measure center of decal itself (not the paper) than measure your surface area for proper aligning. Place a small piece of tape on each end of decal and completely through the center as shown in this picture. This crates a (Hindge)
	Now take your proper aligned decal and remove the small piece of tape from one end. Note: Have your scissors and squeege within reach. Start separating the decal from the backing paper slowly making sure all of the decal stays on the application paper. Lay the decal back making sure not to stick it to anything. Cut the backing paper off as close to the center tap as you can. As shown in this picture.
	Holding the decals in your left hand. Use the squeege in your right hand and starting from the center tape, work the decal down and outward evenly forcing out any air bubbles. As shown in this picture.
Repeat Step 2 for Other Side of Decal	Now remove both other pieces of masking tape and Repeat step 2. The left side of the decal will now hold it in position.

Now that the entire decal is on the surface and squeeged down. Start at one end and begin removing the application tape, pulling it back at a 45 degree angle slowly making sure the decal stays on the surface. If you have any air bubbles left in decal. Use a pin to poke little holes in them and force the air out. If doing a wet application , you will have to wait for awhile before you can remove the application tape, giving time for the moisture to leave under the decal so it will stick to the surface.